Special tools:

- battery lifting tool / holder - ST1201

- inrush limiter


Components:

- new battery pack (including BMS) - see http://shop.vectrixparts.com/category/batteries-battery-pack?horizontal

- Charger - BMS wire harness S02240


  1. Check charger compatibility with Li batteries - refer to SX-BC-CONV
  2. Remove NiMH battery - refer to S-ST-100000
  3. Remove Charger NiMH data harness - refer to SX-000209
  4. Install new Charger - BMS harness S02240 - refer to SX-02240
  5. Install CAN-Bus to MC connector - refer to SX-02240
  6. Install new Li battery:
    1. for LiFePO4 refer to
    2. for Li-ion Nissan Leaf refer to SX-LIMNNL
    3. for Li-ion Amita refer to
  7. Reassemble the bike - S-ST-100000
  8. Upgrade the firmware (charger, MC, ICM) !!Do not upgrade BMS firmware - battery comes with newest firmware!!
    1. for Li-ion (Leaf & Amita) - refer to 36S Li-ion
    2. for Li-Fe (GP and Valence) - refer to 40s LiFe battery
  9. Setup battery capacity via dashboard.
  10. Perform full charging with equalization (first EQ can take longer than usual).


This article was helpful for 8 people. Is this article helpful for you?