DC Power Port Replacement S-XC-S00339

Removal Procedure

1. Remove the left front fairing. Refer to S-XC-S10900 S10800
Note: Mark the terminal connector locations for reassembly (one is 12V+, another is GRND).
2. Remove both DC Power Port terminal connectors (3).

3. Remove the DC Power Port cap by turning the collar (2) counter clockwise.
4. Remove the DC Power Port from the scooter through inside of glovebox.





Installation Procedure

1. Install the DC Power Port through glovebox.2. Install the DC Power Port collar (2) by turning it clockwise and tightening.

3. Install both DC Power Port terminal connectors (3) in the same location as removed.

This article was helpful for 1 person. Is this article helpful for you?